|
eXpand your USB potential
|
The USB specifications describe how data is transmitted in packets, with constraints on packet size defined by endpoint descriptors. The host must not send data payloads larger than the endpoint's maximum packet size.
libusbx and the underlying OS abstract out the packet concept, allowing you to request transfers of any size. Internally, the request will be divided up into correctly-sized packets. You do not have to be concerned with packet sizes, but there is one exception when considering overflows.
When requesting data on a bulk endpoint, libusbx requires you to supply a buffer and the maximum number of bytes of data that libusbx can put in that buffer. However, the size of the buffer is not communicated to the device - the device is just asked to send any amount of data.
There is no problem if the device sends an amount of data that is less than or equal to the buffer size. libusbx reports this condition to you through the libusb_transfer.actual_length field.
Problems may occur if the device attempts to send more data than can fit in the buffer. libusbx reports LIBUSB_TRANSFER_OVERFLOW for this condition but other behaviour is largely undefined: actual_length may or may not be accurate, the chunk of data that can fit in the buffer (before overflow) may or may not have been transferred.
Overflows are nasty, but can be avoided. Even though you were told to ignore packets above, think about the lower level details: each transfer is split into packets (typically small, with a maximum size of 512 bytes). Overflows can only happen if the final packet in an incoming data transfer is smaller than the actual packet that the device wants to transfer. Therefore, you will never see an overflow if your transfer buffer size is a multiple of the endpoint's packet size: the final packet will either fill up completely or will be only partially filled.
1.8.1.2